PREVOST X3-45 COMMUTER User Manual

SECTION 06: ELECTRICAL
DOB 1300-1556 | X3-45 Commuter PA-1648 Maintenance Manual Section 06 revised release October 2021
65
11.4 MAINTENANCE
Regularly inspect the wiring and bus bar
connections to make sure they are clean and
free of corrosion.
1/2-13 power stud nut torque:
180 lb-in (20 Nm)
3/8-16 12V power stud torque:
212 lb-in (24 Nm)
M10-1.5 bus bar ground stud:
240 lb-in (27 Nm)
11.5 HANDLING AND STORAGE
CAUTION
Module should be stored at a minimum voltage
of 8V for the 24V circuit and 4V for the 12V
circuit.
NOTE
The starting module is not a high-voltage
device. It simply supplies the same voltage
that it was charged up to. Handle it with the
same respect you would give to a fully
charged battery.
WARNING
The Starting Module
is a product of high
electric power. Avoid shorting module
terminals!

PREVOST X3-45 COMMUTER Specifications

General

Engine	Volvo D13
Transmission	Allison B500
Fuel Type	Diesel
Length	45 ft (13.7 m)
Width	102 in (2.6 m)
Horsepower	500 hp
GVWR	54, 000 lbs
Height	141 in