EasyManuals Logo

PREVOST X3-45 COMMUTER User Manual

PREVOST X3-45 COMMUTER
744 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #508 background imageLoading...
Page #508 background image
SECTION 18: BODY
18
DOB 1300-1556 | X3-45 Commuter PA-1648 Maintenance Manual First release Oct 2020
Do not drive on gravel roads. Paint finish
easily chips during the first 30 days;
Do not scrape ice or snow from the surface.
A snow scraper can act like a paint scraper if
the finish is new. Brush off loose material
with a soft snow brush.
During the first 90 days:
Do not wax or polish the vehicle. This will
allow the finish to dry and harden
completely.
9.2 PAINT TOUCHUP
When paint touchup or partial repainting is
necessary, refer to the vehicle’s paint scheme
for color codes and paint brand.
Prevost recommends using the original paint
brand to ease color matching.
In the event you sand through to the gelcoat
surface you should prime the area with Standox
“Non Stop Fill Primer (ST-11000)”.
If you sand through to metal surface, first prime
with Standox “Etch Primer (ST-11858)” then with
Standox “Non Stop Fill Primer (ST-11000)”.
CAUTION
Be sure to heed all paint manufacturer’s
recommendations, especially concerning paint
dilution and application.
9.3 PAINTING
The standard paint used on the exterior of the
vehicle is Standox Basislack. It is a high gloss
polyurethane enamel finish designed for
exposure to extreme conditions. Other types of
paint may be called for as options by owner but
are not dealt with in this section.
9.3.1 Safety
Care should be exercised in storing, handling,
mixing, and applying paint and chemicals listed
in this manual. The topcoat, primer, solvent,
catalysts, accelerators, and cleaners are highly
volatile and/or toxic if not properly used. Observe
all safety instructions marked on the different
packaging, as well as the following:
1. Do not smoke in the paint room or in adjacent
area exposed to residue fumes.
2. Wear respirators approved by the governing
safety and health regulations.
3. Maintain adequate ventilation at all times.
4. Dispose of any leftover paint mix properly.
5. Wear rubber gloves, rubber apron, and face
shield during all phases of paint and chemical
handling
9.3.2 Surface Preparation and Paint Application
Aluminum and / or
Stainless Steel
Fiberglass Comments

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PREVOST X3-45 COMMUTER and is the answer not in the manual?

PREVOST X3-45 COMMUTER Specifications

General IconGeneral
EngineVolvo D13
TransmissionAllison B500
Fuel TypeDiesel
Length45 ft (13.7 m)
Width102 in (2.6 m)
Horsepower500 hp
GVWR54, 000 lbs
Height141 in

Related product manuals