PREVOST X3-45 COMMUTER User Manual

SECTION 18: BODY
DOB 1300-1556 | X3-45 Commuter PA-1648 Maintenance Manual First release Oct 2020
23
FIGURE 12: FRONT BUMPER SPRING
Disconnect the bumper supporting arm.
FIGURE 13: BUMPER SUPPORT ARM
Unscrew the four (4) hinge bolts that secure the
bumper hinges to the vehicle and remove the
bumper.
FIGURE 14: BUMPER HINGE BOLTS (4)
10.1.2 Headlights
Refer to Paragraph Headlights, included in
Section 06: Electrical of the Maintenance Manual
for complete information on headlights.
10.1.3 Rear View Mirrors
The mirrors can easily be adjusted by using the
remote controls located on the L.H. side control
panel. The mirrors have easy to replace glass in
case of breakage. Remote control motors can
also be replaced.
FIGURE 15: REAR VIEW MIRROR (ROSCO)
• Adjustment
At the base of the mirror arm, loosen the
mounting bolt to swing arm in or out.
To pivot the mirror head, loosen the set screws
on each side of the ball stub at the base of the
mirror head to facilitate the adjustment.
• Disassembly
At the end of the mirror arm, loosen the set
screws to relieve tension on the ball stem.
Remove the ball stem from the arm.
Remove the four screws fastening the mirror
arm base to the coach.
• Assembly
Mount the mirror arm base to the coach. Insert
the ball stem into the mirror arm and tighten the
socket set screws.

PREVOST X3-45 COMMUTER Specifications

General

Engine	Volvo D13
Transmission	Allison B500
Fuel Type	Diesel
Length	45 ft (13.7 m)
Width	102 in (2.6 m)
Horsepower	500 hp
GVWR	54, 000 lbs
Height	141 in