PREVOST X3-45 COMMUTER User Manual

SECTION 18: BODY
94
DOB 1300-1556 | X3-45 Commuter PA-1648 Maintenance Manual First release Oct 2020
12.3.1 Front Steps Replacement Procedure
MATERIAL
Part No Description Qty
682989 Anti-silicone A/R
683097 Sika 205 (1 liter) A/R
685101 Sika Remover 208 A/R
683916 Sika 215 (1 liter) A/R
1. Cut and remove damaged step(s).
2. Remove dirt and adhesive residue.
NOTE
In wintertime, condensation and cold temperature may greatly influence bonding parameters. Working
area must be at a temperature sufficient to prevent reaching condensation point. Mechanically preheat
working area (heat lamp or heat gun) or wait until vehicle reaches room temperature.
PREPARATION OF “TARABUS” FLOOR COVERING
1. Sand under step using “Scotchbrite”.
2. Clean using anti-silicone (refer to Section A).
Section A Alcohol or Anti-silicone
1. Apply 2. Dry immediately
3. Allow drying
Mandatory Minimum time : Wait for product to evaporate
After 2 hours: Start cleaning operation again
Before applying any other
product
If surface seems dusty, greasy or with finger marks, start cleaning
operation again.
3. Apply Sika Primer 215 (refer to Section D).
CHIX cloth Blue cloth

PREVOST X3-45 COMMUTER Specifications

General

Engine	Volvo D13
Transmission	Allison B500
Fuel Type	Diesel
Length	45 ft (13.7 m)
Width	102 in (2.6 m)
Horsepower	500 hp
GVWR	54, 000 lbs
Height	141 in