PREVOST X3-45 COMMUTER User Manual

SECTION 18: BODY
DOB 1300-1556 | X3-45 Commuter PA-1648 Maintenance Manual First release Oct 2020
49
10.3 ZONE 3
FIGURE 81: ZONE 3
18626
10.3.1 Rear Cap
The fiberglass rear cap does not need any
maintenance except painting as needed. It is
held in place with adhesive. If ever it has to be
replaced, take an appointment at a Prevost
service center near you. For minor damages,
refer to Paragraph 4 "Common Fiberglass
Repair Procedure" and Paragraph 5 "Common
Painting Procedure".
10.3.2 Engine Compartment Door
The engine compartment door may be adjusted
for proper fit by untightening support bolts:
NOTE
Consult the “BODY PANEL AND WINDOW
SPACING DIAGRAM” for proper door gaps
adjustment. (Figure 152)
1. To adjust the door VERTICAL position,
loosen the bolts (4 on each side) holding the
door supporting arm and gas springs bracket
to the vehicle structure (Erreur ! Source du
renvoi introuvable.).
2. To adjust the door LATERAL position,
loosen the bolts (3 on each side) holding the
door supporting arm and gas springs bracket
to the door (Erreur ! Source du renvoi
introuvable.).
3. Adjust the door FORE & AFT position by
screwing/unscrewing the rubber door stops
on each side of the door opening (Erreur !
Source du renvoi introuvable.).
4. Check that the door swings freely and close
properly. It may be necessary to adjust the
door latch to get proper fit and operation.
To adjust the latch mechanism and the striker
pin:
1. Open the door to access the striker pin.
2. Slightly loosen the striker pin.

PREVOST X3-45 COMMUTER Specifications

General

Engine	Volvo D13
Transmission	Allison B500
Fuel Type	Diesel
Length	45 ft (13.7 m)
Width	102 in (2.6 m)
Horsepower	500 hp
GVWR	54, 000 lbs
Height	141 in