PREVOST X3-45 COMMUTER User Manual

DISCONNECTION PROCEDURE PRIOR TO WELDING
Equipment(s): Ratchet handle
3/8" socket
Safety rules: - Wear safety goggles
- Set the battery master switch to the OFF position first
Recommendations: This procedure should be performed by qualified personnel only.
Cover electronic control components and
wiring to protect from hot sparks, etc.
Do not use TIG welding process on the vehicle.
This high frequency current process can
seriously damage the electronic components.
Disconnection procedure prior to welding
PRECAUTIONS TO BE OBSERVED BEFORE ARC
WELDING TO MINIMIZE THE RISK OF MAJOR AND
COSTLY DAMAGES CAUSED TO THE VEHICLE
ELECTRONIC COMPONENTS
1. Turn the ignition switch to the OFF position.

PREVOST X3-45 COMMUTER Specifications

General

Engine	Volvo D13
Transmission	Allison B500
Fuel Type	Diesel
Length	45 ft (13.7 m)
Width	102 in (2.6 m)
Horsepower	500 hp
GVWR	54, 000 lbs
Height	141 in