EasyManuals Logo

PREVOST X3-45 COMMUTER User Manual

PREVOST X3-45 COMMUTER
744 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #409 background imageLoading...
Page #409 background image
SECTION 14: STEERING
DOB 1300-1556 | X3-45 Commuter PA-1648 Maintenance Manual First release Oct 2020
11
Only unfasten the bolts marked with arrows.
FIGURE 7: POWER STEERING PUMP REMOVAL
8. Install the new power steering pump.
Tighten bolts to specification.
TORQUE: 15-21 lb-ft (20-28 Nm)
NOTE
Use a new gasket.
9. Connect the hydraulic lines to the power
steering pump.
10. Install the fuel pump. Torque-tighten bolts
to specification, refer to "Section 03 Fuel
System".
NOTE
Use a new sealing ring. Check that the fuel
pump drive axle sits correctly in the power
steering pump.
11. Start the engine and let run for 5 minutes.
Make sure that there are no leaks.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PREVOST X3-45 COMMUTER and is the answer not in the manual?

PREVOST X3-45 COMMUTER Specifications

General IconGeneral
EngineVolvo D13
TransmissionAllison B500
Fuel TypeDiesel
Length45 ft (13.7 m)
Width102 in (2.6 m)
Horsepower500 hp
GVWR54, 000 lbs
Height141 in

Related product manuals