R&S SMA100B - Source > Noise Generator Settings

Analog modulations
R&S
®
SMA100B
119User Manual 1178.3834.02 ─ 09
5.4.7.3 Source > noise generator settings
Access:
► Select "Modulation" > "Modulation Sources > Noise Generator".
The "Noise Generator" settings contain all parameters to configure the signal of the
internal noise generator.
Settings
Distribution...................................................................................................................119
Bandwidth....................................................................................................................119
Distribution
Selects the distribution of the noise power density.
"Gauss"
Generates the noise power according to a Gaussian distribution.
"Equal"
Generates an evenly distributed noise.
Remote command:
[:SOURce<hw>]:NOISe:DISTribution on page 678
Bandwidth
Sets the noise bandwidth as distinct value.
You can set the bandwidth between 100 kHz and 10 MHz in 100 KHz steps.
Remote command:
[:SOURce<hw>]:NOISe:BANDwidth|BWIDth on page 678
[:SOURce<hw>]:NOISe:BWIDth:STATe on page 678
Modulation settings