R&S SMA100B - Chirp Modulation

Analog modulations
R&S
®
SMA100B
95User Manual 1178.3834.02 ─ 09
Chirp modulation
Access:
► Select "Modulation" > "Chirp Modulation".
The "Chirp Modulation" dialog contains the parameters for configuring the modula-
tion and trigger settings.
State..............................................................................................................................95
Direction........................................................................................................................95
Pulse Period..................................................................................................................96
Bandwidth..................................................................................................................... 96
Trigger Mode.................................................................................................................97
Pulse Width...................................................................................................................97
Compression Ratio........................................................................................................97
Show Connector............................................................................................................97
Execute Single Trigger..................................................................................................97
State
Activates chirp modulation.
Note: Some modulations exclude each other and cannot be performed simultaneously.
For more information, see data sheet.
Remote command:
[:SOURce<hw>]:CHIRp:STATe on page 571
Direction
Selects the direction of the chirp modulation.
Modulation settings