R&S SMA100B - Page 571

Remote control commands
R&S
®
SMA100B
571User Manual 1178.3834.02 ─ 09
Parameters:
<Period> float
Range: 5E-6 (2E-7 with K23) to 100
Increment: 1E-6
*RST: 10E-6
Example: See Example "Perform chirp modulation" on page 569.
Manual operation: See "Pulse Period" on page 96
[:SOURce<hw>]:CHIRp:PULSe:WIDTh <Width>
Sets the width of the generated pulse. The pulse width must be at least 1us less than
the set pulse period.
Parameters:
<Width> float
Range: 2E-6 (1E-7 with K23) to 100
Increment: 1E-6
*RST: 2E-6
Example: See Example "Perform chirp modulation" on page 569.
Manual operation: See "Pulse Width" on page 97
[:SOURce<hw>]:CHIRp:STATe <State>
Activates the generation of a chirp modulation signal.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Example: See Example "Perform chirp modulation" on page 569.
Manual operation: See "State" on page 95
[:SOURce<hw>]:CHIRp:TRIGger:IMMediate
Immediately starts the chirp signal generation.
Example:
See Example "Perform chirp modulation" on page 569.
Usage: Event
Manual operation: See "Execute Single Trigger" on page 97
[:SOURce<hw>]:CHIRp:TRIGger:MODE <Mode>
Selects the trigger mode for the chirp modulation signal.
SOURce subsystem