R&S SMA100B - Settings; Amplitude; RF State;Rf on

RF signal configuration
R&S
®
SMA100B
75User Manual 1178.3834.02 ─ 09
The "Level" tile indicates the level limit, the user correction status and current cor-
rection value, current setting characteristics incl. mode.
The remote commands required to define the settings are described in Chap-
ter 14.16.11, "SOURce:POWer subsystem", on page 681.
Settings
RF State/RF ON............................................................................................................75
Amplitude...................................................................................................................... 75
Limit...............................................................................................................................76
Offset.............................................................................................................................76
Setting Characteristics.................................................................................................. 76
Harmonic Filter..............................................................................................................77
Level Range..................................................................................................................77
Readjust........................................................................................................................78
User Variation................................................................................................................78
└ Variation Active............................................................................................... 78
└ Variation Step..................................................................................................78
RF State/RF ON
Activates or deactivates the RF output.
Acts as the [RF on/off] key.
Remote command:
:OUTPut<hw>[:STATe] on page 490
Amplitude
Sets the level of the RF signal.
The value is offset-free and corresponds to the level at the RF connector.
See "RF frequency and level display with a downstream instrument" on page 66.
Note: Suppressed values in the status bar
For security concerns or certain operating modes, you can hide the frequency and
level display in the status bar.
●
The display has been disabled for security reasons.
See:
– Annotation Frequency
– Annotation Amplitude
RF level settings