R&S SMA100B - Next Window List

Improving level performance
R&S
®
SMA100B
276User Manual 1178.3834.02 ─ 09
This parameter is only available for Configure measurement settings > "Time".
Remote command:
n.a.
State - Gate
Enables time gated measurement. The measurement is started with the "Start" button
in the main measurement diagram. Both gates are active at one time.
The gate borders and the measurement values (average and peak power) are indica-
ted in/below the measurement diagram. The indication is only available for certain dia-
gram views which are switched with the "Rearrange" key.
Remote command:
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STATe on page 499
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:AVERage? on page 497
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:MAXimum? on page 498
:TRACe[:POWer]:SWEep:MEASurement:GATE:DISPlay:ANNotation[:STATe]
on page 544
Start / Stop - Gate
Sets the start and the stop times for the respective gate.
Remote command:
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STARt on page 499
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STOP on page 499
Next window list
Access:
1. Select "Clk Syn/Power Sens" > "NRP-Z Power Analysis".
2. Select "Configure" > "Next Window List"
Using power sensors