R&S SMA100B - LF Signal Output Settings

Analog modulations
R&S
®
SMA100B
120User Manual 1178.3834.02 ─ 09
5.4.8 LF signal output settings
Access:
► Select "Modulation" > "LF Output".
In the "LF Output" tab, you can configure the signal at the LF outputs, determine
the output voltage or add a DC offset. Activate both paths to output the sum signal
of the two sources.
Settings:
State............................................................................................................................120
Source.........................................................................................................................121
Show Connector..........................................................................................................121
Output Voltage............................................................................................................ 121
DC-Offset.................................................................................................................... 121
Load Impedance......................................................................................................... 121
Noise Level................................................................................................................. 122
└ Noise Density................................................................................................122
└ Noise Level................................................................................................... 122
State
Activates the output of the LF signal.
Remote command:
[:SOURce]:LFOutput<ch>[:STATe] on page 657
Modulation settings