R&S SMA100B - Chirp Modulation Settings

Analog modulations
R&S
®
SMA100B
94User Manual 1178.3834.02 ─ 09
The nominal level is used for typically 3 ms to 5 ms after level or frequency setting, if:
●
No attenuator is fitted.
●
"High Power" mode is enabled.
●
"Auto" mode is enabled, and if the level is in the range of the high power, i.e. the
mechanical relay bypass is switched.
For more information, see data sheet.
5.4.3.1 Chirp modulation settings
Option: see Chapter 5.1, "Required options", on page 81.
● Chirp modulation.....................................................................................................95
● Pulse external / trigger............................................................................................ 97
Modulation settings