R&S SMA100B - Preset, Set to Default and Factory Preset Settings

File and data management
R&S
®
SMA100B
313User Manual 1178.3834.02 ─ 09
Presetting the instrument to a user-defined instrument state
The reset functions set the parameters and operating modes to default values prede-
fined by the factory. Alternatively to these default settings, you can:
●
Define user-specific recall settings to be restored after a preset
(see Chapter 11.2.3, "How to recall user settings automatically after preset",
on page 315)
●
Store and reload user-defined instrument states
(see Chapter 11.4.2, "How to save and recall instrument settings", on page 320)
Mark / Do not mark parameters changed from preset
To survey the current state of the settings concerning default values, the
R&S SMA100B offers a feature that visually identifies deviations from the default val-
ues.
For more information, see Chapter 11.2.2, "How to identify parameters which are not in
a preset state", on page 314.
11.2.1 Preset, set to default and factory preset settings
Preset..........................................................................................................................313
Set To Default..............................................................................................................313
Preset this Parameter................................................................................................. 313
Execute Factory Preset...............................................................................................314
Preset
Resets all parameters and switching states, and closes all opened dialogs.
Note:
In contrast to the [Preset] key, the SCPI commands *RST and :SYSTem:PRESet do
not close open dialogs in the GUI.
Consider also the following possibilities:
●
You can define the settings that are restored when you preset the instrument
(see Chapter 11.2.3, "How to recall user settings automatically after preset",
on page 315)
●
You can reset the instrument to the factory state
(see "Execute Factory Preset" on page 314)
See also Table 11-1 that contains the key parameters that are reset by the correspond-
ing preset functions.
Remote command:
*RST on page 453
Set To Default
Resets the associated settings of the corresponding dialog or tab.
Preset this Parameter
Restores the default value of a single parameter.
Restoring the (default) instrument configuration