R&S SMA100B - Noise Generator

Remote control commands
R&S
®
SMA100B
678User Manual 1178.3834.02 ─ 09
14.16.8.1 Noise generator
[:SOURce<hw>]:NOISe:BANDwidth|BWIDth.....................................................................678
[:SOURce<hw>]:NOISe:BWIDth:STATe............................................................................ 678
[:SOURce<hw>]:NOISe:DISTribution............................................................................... 678
[:SOURce<hw>]:NOISe:LEVel:RELative?......................................................................... 678
[:SOURce<hw>]:NOISe:LEVel[:ABSolute]?.......................................................................679
[:SOURce<hw>]:NOISe:BANDwidth|BWIDth <BWidth>
Sets the noise level in the system bandwidth when bandwidth limitation is enabled.
Parameters:
<BWidth> float
Range: 100E3 to 10E6
Increment: 100E3
*RST: 100E3
Example: See Example "Configuring the noise generator" on page 677.
Manual operation: See "Bandwidth" on page 119
[:SOURce<hw>]:NOISe:BWIDth:STATe <State>
Activates noise bandwidth limitation.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Example: See Example "Configuring the noise generator" on page 677.
Manual operation: See "Bandwidth" on page 119
[:SOURce<hw>]:NOISe:DISTribution <Distribution>
Sets the distribution of the noise power density.
Parameters:
<Distribution> GAUSs | EQUal
*RST: GAUSs
Example: See Example "Configuring the noise generator" on page 677.
Manual operation: See "Distribution" on page 119
[:SOURce<hw>]:NOISe:LEVel:RELative?
Queries the level of the noise signal per Hz in the total bandwidth.
SOURce subsystem