R&S SMA100B - Creating Screenshots of Current Settings; Hardcopy Settings

File and data management
R&S
®
SMA100B
336User Manual 1178.3834.02 ─ 09
you would like to distribute the files to several instruments. If the R&S SMA100Bs are
connected to a LAN, you can create a shortcut on the instruments to the file server.
To access the file server
1. On each R&S SMA100B, map the required directory of the file server to the instru-
ment.
Perform the steps described in Chapter 11.8.4, "How to map a network folder",
on page 328.
2. On each R&S SMA100B, use the same alias name for the directory of the file
server, i.e. enter the same "Local Folder" (in this example Setups).
On any of the R&S SMA100B, you access the file server directly from the "File
Manager" and under the same name, e.g. /shares/Setups.
An extra advantage in remote control is that the same application program would
control the instruments.
For example, use the remote control command MMEMory:CDIRectory
"/shares/Setups" to set the default directory for mass storage.
11.10 Creating screenshots of current settings
The save/recall function enables you to save current settings in a file. To document the
most important settings for a performed signal generation, you can also save a hard-
copy of the current display.
● Hardcopy settings................................................................................................. 336
● How to save a hardcopy of the display................................................................. 340
11.10.1 Hardcopy settings
Access:
► Select "System Config > Setup > User Interface > Hardcopy".
Creating screenshots of current settings