R&S SMA100B - Source:vor Subsystem

Remote control commands
R&S
®
SMA100B
625User Manual 1178.3834.02 ─ 09
Manual operation: See "Marker Frequency" on page 162
[:SOURce<hw>][:ILS]:MBEacon[:MARKer]:DEPTh <Depth>
Sets the modulation depth of the marker signal for the ILS marker beacon signal.
Parameters:
<Depth> float
Range: 0 to 100
Increment: 0.1
*RST: 95
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 596.
Manual operation: See "Marker Depth" on page 162
[:SOURce<hw>][:ILS]:MBEacon:PRESet
Sets the parameters of the ILS marker beacons component to their default values
(*RST values specified for the commands).
For other ILS preset commands, see [:SOURce<hw>]:ILS:PRESet on page 598.
Example:
SOURce1:ILS:MBEacon:PRESet
Usage: Event
[:SOURce<hw>][:ILS]:MBEacon[:MARKer]:PULSed <Pulsed>
Activates the modulation of a pulsed marker signal (morse coding).
Parameters:
<Pulsed> 1 | ON | 0 | OFF
*RST: 0
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 596.
Manual operation: See "Pulsed Marker" on page 162
14.16.2.5 SOURce:VOR subsystem
Option: R&S SMAB-K25
The SOURce:VOR subsystem contains all commands for configuring the VOR signal.
Characteristics which are valid for all modulations and the LF output are configured in
the SOURce:LFOutput subsystem. The signal is output at the LF connector.
SOURce subsystem