R&S SMA100B - Page 624

Remote control commands
R&S
®
SMA100B
624User Manual 1178.3834.02 ─ 09
[:SOURce<hw>][:ILS]:MBEacon:COMid[:STATe] <State>
Enables/disables the COM/ID signal.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 596.
Manual operation: See "COM/ID State" on page 164
[:SOURce<hw>][:ILS]:MBEacon:FREQuency <CarrierFreq>
Sets the carrier frequency for the ILS marker beacon signal.
Parameters:
<CarrierFreq> float
Range: 100E3 to 6E9
Increment: 0.01
*RST: 75E6
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 596.
Manual operation: See "Carrier Frequency" on page 161
[:SOURce<hw>][:ILS]:MBEacon:FREQuency:MODE <Mode>
Sets the carrier frequency mode of the ILS marker beacon signal.
Parameters:
<Mode> USER | PREDefined
*RST: USER
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 596.
Manual operation: See "Carrier Frequency Mode" on page 161
[:SOURce<hw>][:ILS]:MBEacon:MARKer:FREQuency <Frequency>
Sets the modulation frequency of the marker signal for the ILS marker beacon modula-
tion signal.
Parameters:
<Frequency> 400 | 1300 | 3000
*RST: 400
Default unit: Hz
Example: See Example "Configure and generate an ILS marker beacons
signal" on page 596.
SOURce subsystem