R&S SMA100B - Page 164

Avionic standards
R&S
®
SMA100B
164User Manual 1178.3834.02 ─ 09
Settings
COM/ID State..............................................................................................................164
Code............................................................................................................................164
Period..........................................................................................................................164
Frequency................................................................................................................... 164
Depth...........................................................................................................................164
Time Schema.............................................................................................................. 164
Dot Length...................................................................................................................165
Dash Length................................................................................................................165
Symbol Space.............................................................................................................165
Letter Space................................................................................................................165
COM/ID State
Enables/disables the COM/ID signal.
See also Chapter D, "Morse code settings", on page 784.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid[:STATe] on page 624
Code
Sets the coding of the COM/ID signal by the international short name of the airport
(e.g. MUC for the Munich airport).
The COM/ID tone is sent according to the selected code, see Chapter D, "Morse code
settings", on page 784.
If no coding is set, the COM/ID tone is sent uncoded (key down).
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:CODE on page 621
Period
Sets the period of the COM/ID signal.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:PERiod on page 623
Frequency
Sets the frequency of the COM/ID signal.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:FREQuency on page 622
Depth
Sets the AM modulation depth of the COM/ID signal.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:DEPTh on page 621
Time Schema
Sets the time schema of the Morse code for the COM/ID signal.
●
"Standard"
ILS configuration and settings