R&S SMA100B - Source:correction Subsystem

Remote control commands
R&S
®
SMA100B
634User Manual 1178.3834.02 ─ 09
Parameters:
<Frequency> float
Range: 5E3 to 15E3
Increment: 0.01
*RST: 9.96E3
Example: See Example "Configure and generate a VOR signal"
on page 596.
Manual operation: See "Subcarrier Frequency" on page 138
[:SOURce<hw>]:VOR:VAR:FREQuency
<Frequency>
Sets the frequency of the variable and the reference signal. As the two signals must
have the same frequency, the setting is valid for both signals.
Parameters:
<Frequency> float
Range: 10 to 60
Increment: 0.01
*RST: 30
Example: See Example "Configure and generate a VOR signal"
on page 596.
Manual operation: See "VAR/REF Frequency" on page 138
[:SOURce<hw>]:VOR:VAR[:DEPTh] <Depth>
Sets the AM modulation depth of the 30Hz variable signal.
Parameters:
<Depth> float
Range: 0 to 100
Increment: 0.1
*RST: 30
Example: See Example "Configure and generate a VOR signal"
on page 596.
Manual operation: See "VAR Depth" on page 138
14.16.3 SOURce:CORRection subsystem
The SOURce:CORRection subsystem contains the commands for defining correction
values for external test assemblies.
You can acquire the correction values anytime, regardless of the modulation settings of
the generator. The correction is performed by adding the correction values to the out-
put level of the respective RF frequency.
SOURce subsystem