Getting started
R&S
®
SMA100B
35User Manual 1178.3834.02 ─ 09
The switch is located on the rear panel.
The LED of the [On/Standby] key is orange.
2. Press the [On/Standby] key.
Key and LED are located on the front panel.
The LED changes to green. The R&S SMA100B boots.
When starting for the first time, the R&S SMA100B starts with the default settings.
When restarting the instrument, the settings depend on the instrument configura-
tion before shut-down.
See Chapter 11.4, "Saving and recalling instrument settings", on page 317.
When the instrument is switched on, it automatically monitors main functions. You can
query erroneous functions. In addition to automatic monitoring, you can perform main-
tenance tasks.
See:
●
Chapter 15.4, "Querying notifications", on page 749
●
Chapter 17.3, "Performing maintenance tasks", on page 761
To shut down the product
The product is in the ready state.
► Press the [On/Standby] key.
The operating system shuts down. The LED changes to orange.
In the standby state, the power switch circuits are active. To deactivate them, discon-
nect the instrument from the power supply.
To disconnect from power
The R&S SMA100B is in the standby state.
1.
NOTICE! Risk of data loss. If you disconnect the product from power when it is in
the ready state, you can lose settings and data. Shut it down first.
Set the toggle switch on the power supply to position [0].
The LED of the [On/Standby] key is switched off.
2. Disconnect the R&S SMA100B from the power source.
3.2 Instrument tour
This chapter explains the control elements and the connectors of the R&S SMA100B.
The views of the front panel and the rear panel help you to get familiar with the instru-
ment and to perform first steps. For specifications of the interfaces, see the data sheet.
The meanings of the labels on the R&S SMA100B are described in Chapter 1.2,
"Labels on R&S SMA100B", on page 21.
Instrument tour
To Next Page
Loading...
