R&S SMA100B - System Subsystem

Remote control commands
R&S
®
SMA100B
712User Manual 1178.3834.02 ─ 09
Suffix:
<ch>
.
1 to 10
Marker
Parameters:
<FState> 1 | ON | 0 | OFF
*RST: 0
Example: See [:SOURce<hw>]:SWEep[:FREQuency]:MARKer<ch>:
FREQuency on page 711.
Options: R&S SMAB-B28
Manual operation: See "State" on page 200
14.17
SYSTem subsystem
The SYSTem subsystem contains a series of commands for general functions which do
not directly affect signal generation.
Example: Retrieving instrument specification
Note: The following values are merely an example.
// Retrieving information on the data sheet versions
// query all data sheet versions stored in the instrument:
:SYSTem:SPECification:VERSion:CATalog?
"04.03,04.02,04.01,04.00,03.04,03.03,03.02,03.01,03.00,02.96,02.95,02.94,
02.02,02.01,02.00,01.03,01.02,01.01,01.00"
// query the initial data sheet version on delivery
:SYSTem:SPECification:VERSion:FACTory?
"04.00"
// select a specific data sheet version:
:SYSTem:SPECification:VERSion "04.01"
// Retrieving information on the data sheet parameters
// with respect to a poarticular data sheet
// query the IDs of all parameters listed in the selected version:
:SYSTem:SPECification:VERSion "04.03"
:SYSTem:SPECification:IDENtification:CATalog?
"ID_RF_FREQ_SETTING_TIME_ALC_ON_MS,ID_RF_FREQ_SETTING_TIME_MS,..."
// query the data sheet information on a specific parameter,
// defined by its ID
:SYSTem:SPECification? "ID_RF_FREQ_SETTING_TIME_ALC_ON_MS"
// returns the specified and, if available,
// the typical value of the parameter.
SYSTem subsystem