R&S SMA100B - Setting Security Parameters; Update Policy Security Settings

General instrument functions
R&S
®
SMA100B
363User Manual 1178.3834.02 ─ 09
12.4.2 Setting security parameters
Access:
► Select "System Config > Setup > Security > Security > General".
In the "General" tab, you can determine the security level for firmware updates, and
configure the security settings for the mass memory and manual operation.
All modified settings in this dialog are not applied until you enter the Security Password
and confirm with Accept.
12.4.2.1 Update policy security settings
Access:
► Select "System Config > Setup > Security > Security > General > SW Update".
The SW Update tab enables you to select the security mode for firmware updates.
The remote commands available to control security settings are described in Chap-
ter 14.17, "SYSTem subsystem", on page 712.
Using the security settings