Network operation and remote control
R&S
®
SMA100B
417User Manual 1178.3834.02 ─ 09
For information on how to perform the configurations, refer to the documentation of
the operating system the computer uses.
13.7.5 How to use computer names (hostnames)
In a LAN that uses a DNS server, each PC or instrument connected in the LAN can be
accessed via an unambiguous computer name (hostname) instead of the IP address.
The DNS server translates the hostname to the IP address. It is especially useful when
a DHCP server is used, as a new IP address can be assigned each time the instru-
ment is restarted.
Each instrument is delivered with an assigned computer name, that remains perma-
nent as long as it is not explicitly changed.
The default computer name follows the syntax <INST>-<Serial Number>, where:
●
<INST> is the short name of your instrument, as stated on the front panel.
●
<Serial Number> is the individual serial number of the instrument.
You can find the serial number at the rear panel of instrument. It is the third part of
the device ID printed on the barcode sticker .
Example:
The default hostname of an R&S SMA100B with a serial number 102030 is
SMA100B-102030.
To query and change a computer name
1. Select "System Config > Remote Access > Network".
The computer name is displayed under "Hostname".
2. Select "System Config > Setup > Security > Protection".
3. Enable the "Protection Level 1".
The default password is 123456.
The parameter "Hostname" in the "Network" tab is now enabled for configuration.
4. Change the "Hostname".
13.8 Controlling the R&S SMA100B remotely
This section shows you how to set up remote control connections over the available
interfaces.
Controlling the R&S
SMA100B remotely