R&S SMA100B - GPIB Address Settings; RS232 Settings

Network operation and remote control
R&S
®
SMA100B
402User Manual 1178.3834.02 ─ 09
13.5.3 GPIB address settings
Access:
► Select "System Config > Remote Access > GPIB Address".
The "GPIB Address" enables you to select the channel for remote control over the
IEC/IEE bus interface.
The remote command to configure the setting remotely is described in Chapter 14.17,
"SYSTem subsystem", on page 712.
Settings:
GPIB Channel Address...............................................................................................402
GPIB Channel Address
Sets the GPIB (IEC/IEEE bus) channel address for the connected instrument.
Remote command:
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess on page 723
13.5.4 RS232 settings
Access:
► Select "System Config > Remote Access > RS232".
The "RS232" dialog enables you to control the instrument over a serial interface
using a USB adapter. The controller and the instrument must be connected with
the external USB/serial-adapter R&S TS1-USB (see recommended extras in the
data sheet) and a serial crossover (null modem) cable. The USB connection
requires the Visa library to be installed on the controller. Visa detects and config-
ures the R&S SMA100B automatically when the USB connection is established.
Remote access settings