R&S SMA100B - ALC Settings

Improving level performance
R&S
®
SMA100B
218User Manual 1178.3834.02 ─ 09
1
2
3
4
Figure 8-1: External ALC setup
1 = RF output connector
2 = Leveled output
3 = Negative polarity detector diode
4 = Ext1 input connector
How to: see Chapter 8.2.2, "How to set up an external ALC", on page 220.
8.2.1 ALC settings
Access:
► Select "Level" > "Automatic Level Control".
In the "ALC" dialog, you can configure the settings for the automatic level control of
the RF signal to achieve optimal accuracy.
The remote commands required to define these settings are described in Chap-
ter 14.16.11, "SOURce:POWer subsystem", on page 681.
Automatic level control (ALC)