Maintenance, storage and disposal
R&S
®
SMA100B
772User Manual 1178.3834.02 ─ 09
Check For Updates
Check for updates of the FPGA/µC.
Remote command:
n.a.
Assembly
The table shows the installed assemblies and their states.
"Assembly"
Assembly designation.
"State"
Indicates the current state of installed assemblies.
Install
Install all available updates for the FPGA/µC.
Remote command:
n.a.
Shut down
For at least one assembly "State = Done" and no pending assemblies, shuts the instru-
ment down to applies installed updates.
Remote command:
:SYSTem:SHUTdown on page 736
Update External Devices
This dialog shows the update options of external devices connected to the instrument.
Check For Updates ← Update External Devices
Check for updates of external devices.
Remote command:
n.a.
17.3.5 Exchanging the RF adapter port
It is important, that you take care that the RF connectors applied to the port are clean,
mechanically compatible and not damaged. Although the 1.85 mm adapter is designed
to withstand several hundred mating cycles, it can reach the end of life or be damaged.
Thererfore, the adapter port is exchangeable, and you can replace it.
For the corresponding instructions on how to proceed, see the R&S SMA100B Service
Manual provided on the global Rohde & Schwarz information system under https://
gloris.rohde-schwarz.com.
17.4 Disposal
Rohde & Schwarz is committed to making careful, ecologically sound use of natural
resources and minimizing the environmental footprint of our products. Help us by dis-
posing of waste in a way that causes minimum environmental impact.
Disposal
To Next Page
Loading...
