R&S SMA100B - Display and Keyboard Settings

General instrument functions
R&S
®
SMA100B
343User Manual 1178.3834.02 ─ 09
In detail described in the following paragraphs, you can:
●
Set display and keyboard language, see Chapter 12.1.1, "Display and keyboard
settings", on page 343
●
Set date and time for the system clock, see Chapter 17.3.2, "Date and time",
on page 766
●
Configure and activate a Screen Saver
●
Deactivate display update to improve performance, see Chapter 12.1.2, "Display
update settings", on page 344
●
Determine the state of the RF signal, and the level display in the status bar when
you turn on the R&S SMA100B, see Chapter 12.1.3, "Defining the RF signal state
on power on", on page 345.
12.1.1 Display and keyboard settings
Access:
1. Select "System Config > Setup > User Interface > Display/Keyboard > Display".
2. Select "Display/Keyboard > USB Keyboard".
In the "Display/Keyboard" dialog, you can change regional and language options
for the GUI and an external keyboard, and define the screen saver settings.
The remote commands required to configure the display and keyboard are described in
Chapter 14.9, "DISPlay subsystem", on page 477 and Chapter 14.12, "KBOard sub-
system", on page 488.
Screen Saver.............................................................................................................. 344
Wait Time.................................................................................................................... 344
Display........................................................................................................................ 344
RF Hardkey.................................................................................................................344
USB Keyboard > Layout..............................................................................................344
Customizing the user interface