R&S SMA100B - Level Range Settings

List and sweep mode
R&S
®
SMA100B
196User Manual 1178.3834.02 ─ 09
"Step Logarithmic"
The step width is determined logarithmically in %, i.e. as a constant
fraction of the current frequency.
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:STEP[:LINear] on page 706
[:SOURce<hw>]:SWEep[:FREQuency]:STEP:LOGarithmic on page 706
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP[:LINear] on page 664
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP:LOGarithmic
on page 664
7.5.3 Level range settings
Access:
1. Select "Sweep" > "RF Level Sweep"
2. Select for example "Level Range".
Table 7-9: Range settings dialog: Examples of RF Level and RF Combined Sweep dialogs
> "Level Range" > "Frequency / Level Range"
Settings
Start Level / Stop Level...............................................................................................196
Step Count.................................................................................................................. 197
Spacing....................................................................................................................... 197
Step.............................................................................................................................197
Setting Characteristics................................................................................................ 197
Sweep Level Range....................................................................................................198
Start Level / Stop Level
Defines the RF level sweep range by setting the start and end values.
See Chapter 7.2.1, "Correlating parameters in sweep mode", on page 181.
Remote command:
RF level sweep:
[:SOURce<hw>]:POWer:STARt on page 688
[:SOURce<hw>]:POWer:STOP on page 688
RF combined sweep:
[:SOURce<hw>]:COMBined:POWer:STARt on page 707
[:SOURce<hw>]:COMBined:POWer:STOP on page 708
Sweep mode settings