R&S SMA100B - Page 664

Remote control commands
R&S
®
SMA100B
664User Manual 1178.3834.02 ─ 09
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SPACing <Spacing>
Selects linear or logarithmic sweep spacing.
Parameters:
<Spacing> LINear | LOGarithmic
*RST: LINear
Example: See Example "Setup an LF sweep" on page 652.
Manual operation: See "Spacing" on page 192
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP:LOGarithmic
<Logarithmic>
Sets the step width factor for logarithmic sweeps to calculate the frequencies of the
steps.
For information on how the value is calculated and the interdependency with other
parameters, see Chapter 7.2.1, "Correlating parameters in sweep mode", on page 181
Parameters:
<Logarithmic> float
The unit is mandatory
Range: 0.01 to 100
Increment: 0.01
*RST: 1
Default unit: PCT
Example: See Example "Setup an LF sweep" on page 652.
Manual operation: See "Step Linear/Step Logarithmic" on page 195
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP[:LINear] <Linear>
Sets the step width for the linear sweep.
For information on how the value is calculated and the interdependency with other
parameters, see Chapter 7.2.1, "Correlating parameters in sweep mode", on page 181
Parameters:
<Linear> float
Range: 0.1 to STOP-STARt
Increment: 0.1
*RST: 1000
Example: See Example "Setup an LF sweep" on page 652.
Manual operation: See "Step Linear/Step Logarithmic" on page 195
SOURce subsystem