R&S SMA100B - Page 663

Remote control commands
R&S
®
SMA100B
663User Manual 1178.3834.02 ─ 09
Manual operation: See "Mode" on page 189
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:POINts <Points>
Sets the number of steps in an LF sweep.
For information on how the value is calculated and the interdependency with other
parameters, see Chapter 7.2.1, "Correlating parameters in sweep mode", on page 181
Parameters:
<Points> integer
Range: 2 to POINts
*RST: 50
Example: See Example "Setup an LF sweep" on page 652.
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RETRace
<State>
Activates that the signal changes to the start frequency value while it is waiting for the
next trigger event.
You can enable this feature, when you are working with sawtooth shapes in sweep
mode "Single" or "External Single".
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Manual operation: See "Retrace" on page 190
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RUNNing?
Queries the current status of the LF frequency sweep mode.
Return values:
<State> 1 | ON | 0 | OFF
Example: See Example "Setup an LF sweep" on page 652.
Usage: Query only
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SHAPe <Shape>
Sets the cycle mode for a sweep sequence (shape).
Parameters:
<Shape> SAWTooth | TRIangle
*RST: SAWTooth
Example: See Example "Setup an LF sweep" on page 652.
Manual operation: See "Shape" on page 191
SOURce subsystem