R&S SMA100B - Clock Synthesizer Connectors; LF Modulation Connectors; Pulse Signal Connectors

Getting started
R&S
®
SMA100B
42User Manual 1178.3834.02 ─ 09
The PC 1.85 mm male connector for up to 67 GHz comes with a protective 1.85 mm
female adapter to prevent the sensitive connector from damage.
It is available as a spare part, and can be replaced if damaged. Contact your
Rohde & Schwarz support center or www.rohde-schwarz.com/support for information.
How to: Chapter 3.1.9, "Connecting to RF", on page 32
3.2.1.12 Pulse signal connectors
Pulse Sync
Output signal for synchronizing the pulse generator signal. The synchronization signal
is generated at the beginning of each pulse. For double-pulse generation, the synchro-
nization signal is generated at the beginning of the first pulse.
Pulse Video
Output of the internal pulse generator signal or the looped through pulse signal from
Pulse Ext connector (video signal).
See Chapter 5.4.1, "Pulse modulation settings", on page 84.
Pulse Ext
Input for an external pulse modulation signal or an external trigger/gate signal for the
pulse generator.
3.2.1.13 LF modulation connectors
LF
Output for internal LF generator signal.
See the data sheet and in the user manual, section Chapter 5, "Analog modulations",
on page 81.
Ext
Input for external analog modulation signals.
See Chapter 5, "Analog modulations", on page 81.
3.2.1.14 Clock synthesizer connectors
Clk Syn/Clk Syn N
Connectors for output of the clock synthesizer signal, or the inverted signal.
Instrument tour