R&S SMA100B - ADF Configuration and Settings

Avionic standards
R&S
®
SMA100B
165User Manual 1178.3834.02 ─ 09
The set dot length determines the length of the dash, the symbol space and letter
space of the Morse code.
●
"User"
You can set each length value separately.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:TSCHema on page 623
Dot Length
Sets the length of a Morse code dot.
If "Time Schema > Standard", the dot length value determines also the length of the
dash (= 3 times the dot length), symbol space (= dot length) and letter space (= 3 times
the dot length).
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:DOT on page 622
Dash Length
Requires "Time Schema > User".
Sets the length of a Morse code dash.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:DASH on page 621
Symbol Space
Requires "Time Schema > User".
Sets the length of the Morse code symbol space.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:SYMBol on page 623
Letter Space
Requires "Time Schema > User".
Sets the length of a Morse code letter space.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:COMid:LETTer on page 622
6.5 ADF configuration and settings
Option: R&S SMAB-K25
Access:
► Select "Modulation > Avionic Standards > ADF".
The remote commands required to define ADF settings are described in Chap-
ter 14.16.2.3, "SOURce:ADF subsystem", on page 600.
ADF configuration and settings