R&S SMA100B - Marker Settings

Improving level performance
R&S
®
SMA100B
254User Manual 1178.3834.02 ─ 09
Pow (Y)
For Configure measurement settings > "Power", sets the power values for points A and
B of the reference curve on the x-axis.
Remote command:
:SENSe[:POWer]:SWEep:POWer:REFerence:DATA:YVALues on page 525
:CALCulate[:POWer]:SWEep:POWer:MATH<ch>:YVAL on page 497
Time (X)
For Configure measurement settings > "Time", sets the time values for points A and B
of the reference curve on the x-axis.
Remote command:
:SENSe[:POWer]:SWEep:TIME:REFerence:DATA:XVALues on page 530
:CALCulate[:POWer]:SWEep:TIME:MATH<ch>:XVAL on page 500
Pow (Y)
For Configure measurement settings > "Time", sets the power values for points A and
B of the reference curve on the y-axis.
Remote command:
:SENSe[:POWer]:SWEep:TIME:REFerence:DATA:YVALues on page 530
:CALCulate[:POWer]:SWEep:TIME:MATH<ch>:YVAL on page 500
Save To Ref
Saves the selected trace as reference trace. One reference trace is available at a time.
Remote command:
:SENSe[:POWer]:SWEep:FREQuency:REFerence:DATA:COPY on page 512
:SENSe[:POWer]:SWEep:POWer:REFerence:DATA:COPY on page 525
:SENSe[:POWer]:SWEep:TIME:REFerence:DATA:COPY on page 530
Marker settings
Access:
1. Select "Clk Syn/Power Sens" > "NRP-Z Power Analysis".
2. Select a power sensor button at the bottom power analysis main screen.
The traces dialog opens.
Using power sensors