R&S SMA100B - Configure Diagram

Improving level performance
R&S
®
SMA100B
263User Manual 1178.3834.02 ─ 09
Maps the trace of a sensor that uses separate frequency to the current scaling of the
diagram. Usually the scale is determined by the set frequency range of the generator. If
more than one sensor is active, which use separate frequencies, the scale can also be
determined by the separate frequency range of one of the other sensors.
Remote command:
n.a.
Configure diagram
Access:
1. Select "Clk Syn/Power Sens" > "NRP-Z Power Analysis".
2. Select "Configure" > "Configure Diagram"
The "Configure Diagram" covers the parameters for scaling the y-axis and the appear-
ance of the diagram.
Min - Max Level - Power Analysis
Selects the minimum and maximum value of the y-axis.
Remote command:
:SENSe[:POWer]:SWEep:FREQuency:YSCale:MAXimum on page 516
:SENSe[:POWer]:SWEep:FREQuency:YSCale:MINimum on page 516
:SENSe[:POWer]:SWEep:POWer:YSCale:MAXimum on page 528
:SENSe[:POWer]:SWEep:POWer:YSCale:MINimum on page 529
:SENSe[:POWer]:SWEep:TIME:YSCale:MAXimum on page 533
:SENSe[:POWer]:SWEep:TIME:YSCale:MINimum on page 534
Auto Scale - Power Analysis
Activates autoscaling of the y-axis of the diagram. The "Auto Scale" function adjusts
the scale divisions so that the entire trace fits into the diagram area.
"Off"
Auto scale is deactivated. Switching from activated to be deactivated,
the scaling is maintained.
Using power sensors