R&S SMA100B - Page 516

Remote control commands
R&S
®
SMA100B
516User Manual 1178.3834.02 ─ 09
Usage: Event
Manual operation: See "Reset Auto Scale - Power Analysis" on page 264
:SENSe[:POWer]:SWEep:FREQuency:YSCale:MAXimum <Maximum>
Sets the maximum value for the y axis of the measurement diagram.
Parameters:
<Maximum> float
Range: -200 to 100
Increment: 0.01
*RST: 40
Example:
SENS:SWE:FREQ:YSC:MAX 10DBM
Sets 10 dBm as the upper limit of the measurement diagram.
Manual operation: See "Min - Max Level - Power Analysis" on page 263
:SENSe[:POWer]:SWEep:FREQuency:YSCale:MINimum <Minimum>
Sets the minimum value for the y axis of the measurement diagram.
Parameters:
<Minimum> float
Range: -200 to 100
Increment: 0.01
*RST: -40
Example:
SENS:SWE:FREQ:YSC:MIN -10DB
Sets -10 dBm as the lower limit of the measurement diagram.
Manual operation: See "Min - Max Level - Power Analysis" on page 263
:SENSe[:POWer]:SWEep:HCOPy:DATA?
Queries the measurement data directly. The data is transferred to the remote client as
data stream.
Readable ASCII data is available for hardcopy language CSV. The representation of
the values depends on the selected orientation for the CSV format.
Return values:
<Data> block data
Power sensor measurement subsystems