R&S SMA100B - General Settings

Avionic standards
R&S
®
SMA100B
161User Manual 1178.3834.02 ─ 09
Settings
● General settings....................................................................................................161
● Signal settings.......................................................................................................162
● COM/ID settings....................................................................................................163
6.4.4.1 General settings
Access:
1. Select "ILS Component > Marker Beacons", see Chapter 6.4.4, "ILS marker bea-
cons settings", on page 160.
2. Select "ILS > General".
This dialog comprises carrier frequency and signal settings related to the ILS
marker beacons component of the ILS signal.
Settings
Carrier Frequency Mode............................................................................................. 161
Carrier Frequency....................................................................................................... 161
Carrier Frequency Mode
Sets the mode for the carrier frequency of the signal.
"User Defined"
Activates user-defined variation of the carrier frequency.
"Predefined"
Activates variation of the carrier frequency by integer 25 kHz steps.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:FREQuency:MODE on page 624
Carrier Frequency
Requires "Carrier Frequency Mode > User Defined".
Sets the carrier frequency of the signal.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:FREQuency on page 624
ILS configuration and settings