R&S SMA100B - Trace Settings

Improving level performance
R&S
®
SMA100B
265User Manual 1178.3834.02 ─ 09
Trace settings
Access:
1. Select "Clk Syn/Power Sens" > "NRP-Z Power Analysis".
2. Select "Configure" > "Configure Measurement".
3. Set "Mode" > "Time".
4. Select "Configure Time Mode"
5. Select the "Trace" tab.
The "Trace" tab contains the parameters for the evaluation of important pulse
parameters, provided the used power sensor supports automatic pulse analysis.
Trace
Selects the trace the sensor is assigned to.
To assign a sensor to a trace, use the trace buttons, see Off / NRP-Zxx.
Indication
Indicates the type of power sensor assigned to the selected trace. This field is auto-
matically updated if the sensor is connected or disconnected. Also, this sensor is indi-
cated on the trace button in the measurement diagram.
This parameter is only available for Configure measurement settings > "Time".
Remote command:
n.a.
Using power sensors