R&S SMA100B - Instrument Emulations Settings

Network operation and remote control
R&S
®
SMA100B
403User Manual 1178.3834.02 ─ 09
The remote commands required to configure the parameters remotely are described in
Chapter 14.17, "SYSTem subsystem", on page 712.
Settings:
Baud Rate
Sets the baudrate for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:BAUD on page 726
Parity
Sets the parity for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:PARity on page 726
Stop Bits
Sets the number of stop bits for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:SBITs on page 727
13.5.5 Instrument emulations settings
Access:
► Select "System Config > Remote Access > Instrument Emulations".
Remote access settings