R&S SMA100B - Remote Control States

Network operation and remote control
R&S
®
SMA100B
447User Manual 1178.3834.02 ─ 09
length = length+1;
viWrite (handle, writeBuffer, length, VI_NULL);
//read result
viRead(handle, readBuffer, 100, &readCount);
}
int main (int argc, char *argv[])
{
if (InitCVIRTE (0, argv, 0) == 0)
return -1; /* out of memory */
//create a VISA session and return a handle to it
viOpenDefaultRM (&defaultRM);
//create a VISA session to the serial port and return a handle to it
viOpen (defaultRM, (ViRsrc)"TCPIP::localhost::INSTR", VI_NULL, VI_NULL,
&handle);
#INIT_CODE_END
#COMMAND_CODE_START
write_command("%COMMAND");
#COMMAND_CODE_END
#NO_COMMAND_CODE_START
//no SCPI command available for parameter %PARAMETER !
#NO_COMMAND_CODE_END
#EXIT_CODE_START
viClose (handle);
viClose (defaultRM);
return 0;
}
#EXIT_CODE_END
13.11.3 Remote control states
How to recognize if there is an active remote connection to the instrument
► Observe the indication on the taskbar.
A softkey in the taskbar indicates if and what kind of remote connections are cur-
rently set up.
See also Chapter 13.5.6, "Remote connections settings", on page 405.
The following table shows the different remote control states and the associated com-
mands or actions to return to manual control.
References