R&S SMA100B - Connectors

Getting started
R&S
®
SMA100B
44User Manual 1178.3834.02 ─ 09
8 = V/GHz X-Axis, page 44 and Z-Axis, page 44
9 = Stop, page 45
10 = EFC, page 45
11 = Marker User1, page 45
12 = Inst Trig, page 45
13 = Signal Valid, page 45
14 = Clk Syn/Clk Syn N, page 42
15 = Pulse Sync, page 45, Pulse Video, page 42 and Pulse Ext, page 42
16 = LF, page 42
17 = Ext 1/2, page 46
18 = AC power supply connector and switch, page 46
19 = RF, page 46
3.2.2.1 Connectors
IEC 625/IEEE 488
Option: R&S SMAB-B86
General purpose interface bus (GPIB) interface for remote control of the instrument.
The interface is in compliance with the standards IEC 625, IEEE 488 and SCPI.
Use this interface to connect a computer for remote control of the R&S SMA100B. To
set up the connection, use high-quality shielded cables. See "Cable selection and elec-
tromagnetic interference (EMI)" on page 29.
See also Chapter A.2.1, "GPIB-Bus interface", on page 779 and Chapter 13, "Network
operation and remote control", on page 378.
USB/USB In
●
Female USB (universal serial bus) 2.0 connector of type A (host USB), to connect
devices like a keyboard, a mouse, a memory stick, or the R&S NRP-Z3/Z4 cable
for the R&S NRP power sensors
●
Option: R&S SMAB-B86
Female USB 3.0 connector of type Micro-B (USB In), for example, for remote con-
trol.
How to: Chapter 3.1.8, "Connecting USB devices", on page 31
LAN
RJ-45 connector to connect the R&S SMA100B to a LAN for remote control, remote
operation, and data transfer.
How to: Chapter 3.1.7, "Connecting to LAN", on page 30
V/GHz X-Axis
Output of a voltage ramp:
●
"V / GHz": the voltage is proportional to the frequency.
●
"X-Axis": output of a voltage ramp for the X deflection of an oscilloscope or an XY
recorder.
Z-Axis
Output of a voltage pulse, e.g. for the combined blanking and marker generation of net-
work analyzers.
Instrument tour