R&S SMA100B - How to Query Instrument Configuration

Troubleshooting and notifications
R&S
®
SMA100B
755User Manual 1178.3834.02 ─ 09
LucasFonts RSCorpid EULA
Accesses copyright information on LucasFonts font type RSCorpid EULA.
Hardware Options/Software Options
The tables in the "Hardware" and "Software" tabs list the installed hardware and soft-
ware options.
"Option"
Short name of option
"Designation"
Name of option
"Expiration Date"
For regular options, "Permanent" is indicated in this column. Some
options are available as trial versions. This column shows their expi-
ration date. After this date, the option is no longer available on the
instrument.
Remote command:
*OPT? on page 452
*IDN? on page 451
Versions
The "Versions" tab shows the versions of the technical specification of the
R&S SMA100B and of the software components that comprise the firmware.
"Package"
Name of the component.
"Version"
Current issue of the component.
E.g. the data sheet covers the technical data of the hardware compo-
nents of the factory settings.
See also Chapter 13.6.2.3, "Datasheet", on page 414.
Remote command:
:SYSTem:SPECification:VERSion:FACTory? on page 732
15.7.3 How to query instrument configuration
To get information on the components and installed options of the R&S SMA100B, pro-
ceed as described in the following examples.
Checking the installed hardware options
To find out the installed options:
1. Select "System Config > Setup > Instrument Assembly > Versions/Options".
Requesting instrument configuration and specifications