R&S SMA100B - Page 732

Remote control commands
R&S
®
SMA100B
732User Manual 1178.3834.02 ─ 09
<Parameter> float
An additional value the result (ValList) depends on.
Return values:
<ValList> float
Comma-separated list with the specified and, if available, the
typical value of the parameter, as specified in the data sheet.
Example: Note: The following values are merely an example. Your instru-
ment may not support the same parameters.
SYST:SPEC:PAR? "ID_RF_FREQ_SETTING_TIME_MS",0.1
SYST:SPEC:PAR? "ID_RF_LEVEL_MAX_GENERAL_DBM",
0.1
Usage: Query only
:SYSTem:SPECification:VERSion:CATalog?
Queries all data sheet versions stored in the instrument.
Return values:
<VersCatalog> string
Example: See :SYSTem:SPECification? on page 730.
Usage: Query only
:SYSTem:SPECification:VERSion:FACTory?
Queries the data sheet version of the factory setting.
Return values:
<Version> string
Example: See :SYSTem:SPECification? on page 730.
Usage: Query only
Manual operation: See "Versions" on page 755
:SYSTem:SRData?
Queris the SCPI recording data from the internal file.
This feature enables you to transfer an instrument configuration to other test environ-
ments, as e.g. laboratory virtual instruments.
Return values:
<FileData> block data
SYSTem subsystem