R&S SMA100B - Page 731

Remote control commands
R&S
®
SMA100B
731User Manual 1178.3834.02 ─ 09
Setting parameters:
<Id> string
Identifies the name of the entry in the data sheet, as queried
with the command :SYSTem:SPECification:
IDENtification:CATalog? on page 731
Return values:
<ValList> float
Comma-separated list with the specified and, if available, the
typical value of the parameter, as specified in the data sheet.
See also Chapter 13.6.2.3, "Datasheet", on page 414.
Example: See Example "Retrieving instrument specification" on page 712.
Usage: Query only
:SYSTem:SPECification:VERSion
<Version>
Selects a data sheet version from the data sheets saved on the instrument.
Further queries regarding the data sheet parameters (<Id>) and their values refer to
the selected data sheet.
To query the list of data sheet versions, use the command :SYSTem:
SPECification:VERSion:CATalog? on page 732.
Parameters:
<Version> string
Example: See :SYSTem:SPECification? on page 730.
:SYSTem:SPECification:IDENtification:CATalog?
Queries the parameter identifiers (<Id>) available in the data sheet.
Return values:
<IdList> string
Comma-separated string of the parameter identifiers (<Id>)
Example: See :SYSTem:SPECification? on page 730.
Usage: Query only
:SYSTem:SPECification:PARameter? <Id>[, <Parameter>]
Retrieves data sheet information for a specific parameter.
Setting parameters:
<Id> string
Identifies the name of the entry in the data sheet.
Query the data sheet parameters with the command :SYSTem:
SPECification:IDENtification:CATalog?.
SYSTem subsystem