R&S SMA100B - Configure Measurement Settings; NRP-Z Configure Settings

Improving level performance
R&S
®
SMA100B
255User Manual 1178.3834.02 ─ 09
3. Select the "Markers" tab.
In this dialog, you can assign markers to the corresponding traces and activate
them for dsplay.
Trace - Power Analysis
Selects the trace the marker is assigned to.
Remote command:
n.a.
Marker x Visible - Power Analysis
Selects if the respective marker and the marker list are shown in the diagram.
Remote command:
n.a.
8.4.4.6 NRP-Z configure settings
The "Configure" dialog allows you to set measurement and sensor parameters.
● Configure measurement settings.......................................................................... 255
● Configure sensors settings....................................................................................259
● Configure diagram.................................................................................................263
● Configure time mode settings............................................................................... 264
● Trace settings........................................................................................................265
● Pulse data notifications settings............................................................................267
● Trigger settings..................................................................................................... 272
● Gate mode settings...............................................................................................274
● Next window list.................................................................................................... 276
Configure measurement settings
Access:
1. Select "Clk Syn/Power Sens" > "NRP-Z Power Analysis".
Using power sensors