R&S SMA100B - Accessing the File System of the R&S SMA100 B Via FTP

File and data management
R&S
®
SMA100B
332User Manual 1178.3834.02 ─ 09
2. Enable "LAN Interface"
3. Select "Samba Services".
4. Enable the "SMB 1.0/2.0 Client".
5. Enable the "SMB 1.0/2.0 Server".
6. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 12.4,
"Using the security settings", on page 360.
7. Select "Accept".
To enable file transfer over USB
1. Select "System Config > Setup > Security > Security > General"
2. Select "Disk & Memory".
3. Enable "USB Storage"
4. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 12.4,
"Using the security settings", on page 360.
5. Select "Accept".
11.9.2 Accessing the file system of the R&S SMA100B via FTP
If the R&S SMA100B is connected to a LAN, you can use file transfer protocol (FTP) to
access the file system and to transfer files from and to the instrument.
How to: see Chapter 13.7.3, "How to connect to LAN", on page 415.
To access the file system via FTP
We assume that the instrument and the remote PC are connected to a LAN.
1. Enable file transfer via FTP
2. Enable write permission on the file system
3. On the remote PC, start the Windows Explorer.
4. In the address field, enter ftp://<"IP Address" of the Instrument>, e.g.
ftp://10.124.0.166.
Tip: The R&S SMA100B indicates its IP address on the home screen.
A log-on dialog opens and requests a password.
The default user name and password is instrument.
Tip:
Default password
The FTP and SAMBA file access use the user "instrument" with default password
"instrument".
How to transfer files from and to the instrument