R&S SMA100B - Frequency Range Settings

List and sweep mode
R&S
®
SMA100B
194User Manual 1178.3834.02 ─ 09
7.5.2 Frequency range settings
Access:
1. Select for example "Sweep" > "RF Frequency Sweep"
2. Select for example "Frequency Range".
Table 7-8: Range settings dialog: Examples of RF Frequency and RF Combined Sweep dialogs
> "Frequency Range" > "Frequency / Level Range"
Settings
Start Frequency/Stop Frequency................................................................................ 194
Center Frequency....................................................................................................... 194
Span............................................................................................................................195
Spacing....................................................................................................................... 195
Step Linear/Step Logarithmic......................................................................................195
Start Frequency/Stop Frequency
Defines the frequency sweep range by setting the start and end values.
See Chapter 7.2.1, "Correlating parameters in sweep mode", on page 181.
Remote command:
RF frequency sweep:
[:SOURce<hw>]:FREQuency:STARt on page 647
[:SOURce<hw>]:FREQuency:STOP on page 648
RF combined sweep:
[:SOURce<hw>]:COMBined:FREQuency:STARt on page 707
[:SOURce<hw>]:COMBined:FREQuency:STOP on page 707
LF frequency sweep:
[:SOURce<hw>]:LFOutput:FREQuency:STARt on page 656
[:SOURce<hw>]:LFOutput:FREQuency:STOP on page 656
Center Frequency
In "RF Frequency Sweep" mode, sets the RF center frequency.
See Chapter 7.2.1, "Correlating parameters in sweep mode", on page 181.
Remote command:
[:SOURce<hw>]:FREQuency:CENTer on page 647
Sweep mode settings