R&S SMA100B - Signal Settings

Avionic standards
R&S
®
SMA100B
162User Manual 1178.3834.02 ─ 09
6.4.4.2 Signal settings
Access:
1. Select "ILS Component > Marker Beacons", see Chapter 6.4.4, "ILS marker bea-
cons settings", on page 160.
2. Select "ILS > Signal".
This dialog comprises signal settings related to the ILS marker beacons compo-
nent of the ILS signal.
Settings
Marker Frequency.......................................................................................................162
Marker Depth.............................................................................................................. 162
Pulsed Marker.............................................................................................................162
Marker Frequency
Sets the modulation frequency of the marker signal.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:MARKer:FREQuency on page 624
Marker Depth
Sets the modulation depth of the marker signal.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon[:MARKer]:DEPTh on page 625
Pulsed Marker
Activates the modulation of a pulsed marker signal (morse coding).
ILS configuration and settings