R&S SMA100B - Manual Operation Security Settings

General instrument functions
R&S
®
SMA100B
366User Manual 1178.3834.02 ─ 09
12.4.2.3 Manual operation security settings
Access:
► Select "System Config > Setup > Security > Security > General > Manual Opera-
tion".
The "SW Update" tab enables you to lock front panel operation and/or reading the
display.
The remote commands available to control security settings are described in:
●
Chapter 14.9, "DISPlay subsystem", on page 477
●
Chapter 14.17, "SYSTem subsystem", on page 712.
Annotation Frequency
Enables the display of the currently used frequency in the status bar.
How to: see "Disabling the frequency and level indication in the status bar"
on page 375.
Remote command:
:DISPlay:ANNotation:FREQuency on page 480
Annotation Amplitude
Enables the display of the currently selected level in the status bar.
How to: see "Disabling the frequency and level indication in the status bar"
on page 375.
Remote command:
:DISPlay:ANNotation:AMPLitude on page 480
User Interface
Allows you to lock the controls for manual operation and the display individually.
How to: see "Deactivating the user interface" on page 375.
See also Chapter 12.4, "Using the security settings", on page 360.
"Enabled"
Enables the display and all controls for the manual operation of the
instrument.
Using the security settings